Hinge sets supplied with our gates
See below for some information on hinge sets supplied with our gates.
Please note that we do not sell these sets separately, but we do offer all the components and more for purchase via our online store.
Hook to drive and hook to bolt
Adjustable hinge set for fixing to timber posts.
The professional's choice
Set compatible with all our English gates and timber posts
To raise or lower the far end of the gate, adjust it using the bottom hinge adjustment assembly; you can also adjust the gate or gates laterally. This four-way adjustment is especially useful when hanging a pair of gates and is particularly favoured by professional installers.
For hanging gates from the front, rear, or inside face of a timber post. When hanging on the front or rear face, the gate or gates will open 180 degrees one way. When hanging on the inside face, they will open approximately 120 degrees both ways.
We recommend
A 19mm security collar or anti-theft bracket to prevent unwanted gate removal
Drive in and bolt through
The bottom hook is 225mm long and driven into the post prior to drilling a 20mm pilot hole; the top hook is 325mm long and bolted through the post. The top bolt can be easily adjusted to make lateral adjustments to the post. The bottom adjustable hinge assembly allows the far end of the gate to be raised or lowered.
Strap hinge
Wrap-around strap hinge 600mm long. When ordering our Midsummer helved gates, the correct size hinge for the length of gate ordered will be supplied.
Screw on plates
Easy-to-install adjustable hinge set with hooks on plates for fixing to timber, brick or stone.
Set compatible with all our English gates and timber posts
To raise or lower the far end of the gate, adjust it using the bottom hinge adjustment assembly. This is especially useful when hanging a pair of gates
For hanging gates from the front, rear, or inside face of a timber post or hard stone pillar, it can also be used on stone, brick, or concrete walls. When hanging on the front or rear face, the gate or gates will open 180 degrees one way. When hanging on the inside face, they will open approximately 120 degrees both ways.
We recommend
A 19mm security collar or anti-theft bracket to prevent unwanted gate removal
Plates are 100mm square
Can be installed to timber with the fixings supplied, or to stone, brick, or concrete with additional fixing components of choice. Compatible with all our Midsummer gates and posts.
Strap hinge
Wrap-around strap hinge 600mm long. When ordering our Midsummer helved gates, the correct size hinge for the length of gate ordered will be supplied.
Bolt through
Adjustable hinge set with hooks to bolt through timber posts.
Set compatible with all our English gates and timber posts
This adjustable hinge set allows the installer to raise or lower the gate(s) during and after installation by adjusting the bolts.
The hooks pass through the timber posts up to a thicknes of 230mm
For hanging a single or a pair of gates on the inside face of a timber post. They will open approximately 120 degrees both ways.
We recommend
A 19mm security collar or anti-theft bracket to prevent unwanted gate removal
Bolts are 325mm long
Bolts with hooks are 325mm long and 19mm in diameter, zinc-plated,
Strap hinge
Wrap-around strap hinge 600mm long. When ordering our Midsummer helved gates, the correct size hinge for the length of gate ordered will be supplied.